You set all the parameters in THAT box, not in corel. The same setup panel as in LaserDRW with the controller board number spot on top will come up when you go to laser. Yes, you will be able to cut and engrave and mark (never really got that one).Ĭorel is pretty tough to draw in, so you’ll probably end up drawing/composing in another package (I use Draftsight, because I’m a fossil from the Acad 10 days) and copying it into Corel via. Use the dongle and serial number (same for all users) to activate it. You will be instructed NOT to register it, and can’t. Run it as with any installer, and you should be on the air with Corel 12. I installed WinRAR (from the WinZIP folks) and there was the installer. RAR file which my file viewer (Free Viewer) did not see. Turned out the program installer is buried in a.
I had used the Corel.exe file visible on the disk directory, and it seemed to install fine, but got the error as you did. They described the install process they used and I knew something was wrong. I couldn’t get it to work until I was clued in by I Laser and Yuusuf. The software kit that came with my K40 had Corel 12 included. Will I be able to create files and use in LaserDRW? both cut and engrave? The CorelDRAW(ver >=11) software not installed! Well i bought Coreldraw x7 home and student which is great, but when i run CorelLaser i get a CorelLASER error
